Klipper/Pressure_Advance — Polish @ Hosted Weblate: Pressure advance

	English	Polish	Actions
	Once pressure advance is tuned in Klipper, it may still be useful to configure a small retract value in the slicer (eg, 0.75mm) and to utilize the slicer's "wipe on retract option" if available. These slicer settings may help counteract ooze caused by filament cohesion (filament pulled out of the nozzle due to the stickiness of the plastic). It is recommended to disable the slicer's "z-lift on retract" option.
	The pressure advance system does not change the timing or path of the toolhead. A print with pressure advance enabled will take the same amount of time as a print without pressure advance. Pressure advance also does not change the total amount of filament extruded during a print. Pressure advance results in extra extruder movement during move acceleration and deceleration. A very high pressure advance setting will result in a very large amount of extruder movement during acceleration and deceleration, and no configuration setting places a limit on the amount of that movement.
	SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500
	TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005
	TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.020
	Pressure advance	Pressure advance

Loading…

Mediagott

Translation added

English

Polish 16 characters edited Current translation Translated

2 years ago

Mediagott

Contributor joined

Contributor joined 2 years ago

Source and translation are identical

English	Polish
Pressure advance	Pressure advance	Klipper

md-text

2 years ago

a year ago

2 years ago

docs/locales/pl/LC_MESSAGES/Pressure_Advance.po, string 31