Klipper/Rotation_Distance — Korean @ Hosted Weblate: Rotation distance

Zen

	English	Korean	Actions
	In most cases, gear_ratio should be defined with whole numbers as common gears and pulleys have a whole number of teeth on them. However, in cases where a belt drives a pulley using friction instead of teeth, it may make sense to use a floating point number in the gear ratio (eg, `gear_ratio: 107.237:16`).	대부분의 경우 gear_ratio는 일반 기어와 풀리에 정수의 톱니가 있으므로 정수로 정의해야 합니다. 그러나 벨트가 톱니 대신 마찰을 사용하여 풀리를 구동하는 경우 기어비에 부동 소수점 숫자를 사용하는 것이 합리적일 수 있습니다(예: `gear_ratio: 107.237:16`).
	rotation_distance = <full_steps_per_rotation> * <microsteps> / <steps_per_mm>	rotation_distance = <full_steps_per_rotation> * <microsteps> / <steps_per_mm>
	rotation_distance = <full_steps_per_rotation> * <microsteps> * <step_distance>	rotation_distance = <full_steps_per_rotation> * <microsteps> * <step_distance>
	rotation_distance = <belt_pitch> * <number_of_teeth_on_pulley>	rotation_distance = <belt_pitch> * <number_of_teeth_on_pulley>
	rotation_distance = <screw_pitch> * <number_of_separate_threads>	rotation_distance = <screw_pitch> * <number_of_separate_threads>
	Rotation distance	Rotation distance
	Extrude 50mm of filament with the following command sequence: `G91` followed by `G1 E50 F60`. Note 50mm as `<requested_extrude_distance>`. Wait for the extruder to finish the move (it will take about 50 seconds). It is important to use the slow extrusion rate for this test as a faster rate can cause high pressure in the extruder which will skew the results. (Do not use the "extrude button" on graphical front-ends for this test as they extrude at a fast rate.)
	Almost all printers should have a whole number for `rotation_distance` on X, Y, and Z type axes. If the above formula results in a rotation_distance that is within .01 of a whole number then round the final value to that whole_number.