Klipper/Rotation_Distance — Chinese (Traditional) @ Hosted Weblate: Extrude 50mm of filament with the following command sequence: `G91` …

Translation

English

Extrude 50mm of filament with the following command sequence: `G91` followed by `G1 E50 F60`. Note 50mm as `<requested_extrude_distance>`. Wait for the extruder to finish the move (it will take about 50 seconds). It is important to use the slow extrusion rate for this test as a faster rate can cause high pressure in the extruder which will skew the results. (Do not use the "extrude button" on graphical front-ends for this test as they extrude at a fast rate.)

Chinese (Traditional)

Needs editing

Skip

	English	Chinese (Traditional)	Actions
	rotation_distance = <full_steps_per_rotation> * <microsteps> / <steps_per_mm>	rotation_distance = <full_steps_per_rotation> * <microsteps> / <steps_per_mm>
	rotation_distance = <full_steps_per_rotation> * <microsteps> * <step_distance>	rotation_distance = <full_steps_per_rotation> * <microsteps> * <step_distance>
	rotation_distance = <belt_pitch> * <number_of_teeth_on_pulley>	rotation_distance = <belt_pitch> * <number_of_teeth_on_pulley>
	rotation_distance = <screw_pitch> * <number_of_separate_threads>	rotation_distance = <screw_pitch> * <number_of_separate_threads>
	Rotation distance	旋轉距離
	Extrude 50mm of filament with the following command sequence: `G91` followed by `G1 E50 F60`. Note 50mm as `<requested_extrude_distance>`. Wait for the extruder to finish the move (it will take about 50 seconds). It is important to use the slow extrusion rate for this test as a faster rate can cause high pressure in the extruder which will skew the results. (Do not use the "extrude button" on graphical front-ends for this test as they extrude at a fast rate.)	用以下命令序列擠出50mm長絲：「G91」，後跟「G1 E50 F60」。。注50mm為<requested_extrude_distance>』。等待擠出機完成移動（大約需要50秒）。在此測試中使用緩慢的擠出速率非常重要，因為較快的速率會導致擠出機中的高壓，從而扭曲結果。（請勿在圖形前端使用"拉伸按鈕"進行此測試，因為它們以快速的速度拉伸。
	Almost all printers should have a whole number for `rotation_distance` on X, Y, and Z type axes. If the above formula results in a rotation_distance that is within .01 of a whole number then round the final value to that whole_number.	幾乎所有印表機都應該在 X、Y 和 Z 型軸上具有「rotation_distance」整數。如果上述公式導致rotation_distance在整數的 .01 範圍內，則將最終值捨入為該whole_number。