Klipper

Axis_Twist_Compensation

Polish

Translate

Zen

Translation

English

Polish

Needs editing

Sign in to save the translation.

Skip

	English	Polish	Actions
	Axis Twist Compensation	Kompensacja Obrotu Osi
	This document describes the [axis_twist_compensation] module.	Ten dokument opisuje moduł [axis_twist_compensation]
	Some printers may have a small twist in their X rail which can skew the results of a probe attached to the X carriage. This is common in printers with designs like the Prusa MK3, Sovol SV06 etc and is further described under [probe location bias](Probe_Calibrate.md#location-bias-check). It may result in probe operations such as [Bed Mesh](Bed_Mesh.md), [Screws Tilt Adjust](G-Codes.md#screws_tilt_adjust), [Z Tilt Adjust](G-Codes.md#z_tilt_adjust) etc returning inaccurate representations of the bed.
	This module uses manual measurements by the user to correct the probe's results. Note that if your axis is significantly twisted it is strongly recommended to first use mechanical means to fix it prior to applying software corrections.	Moduł ten wykorzystuje pomiary wykonywane ręcznie przez użytkownika w celu skorygowania wyników sondy. Należy pamiętać, że jeśli oś jest znacznie skrzywiona, zdecydowanie zaleca się najpierw wprowadzić poprawki mechaniczne, aby ją naprawić przed zastosowaniem poprawek programowych.
	Warning: This module is not compatible with dockable probes yet and will try to probe the bed without attaching the probe if you use it.
	Overview of compensation usage
	Tip: Make sure the [probe X and Y offsets](Config_Reference.md#probe) are correctly set as they greatly influence calibration.

Loading…

mattkap

Translation added

English

Polish 52 characters edited Current translation Translated

4 months ago

None

String updated in the repository

English

Polish 0 characters edited Empty

6 months ago

Browse all string changes

Things to check

Mismatched full stop

Source and translation do not both end with a full stop

Glossary

English	Polish
[axis_twist_compensation]		Config_Reference
[axis_twist_compensation]		G-Codes

String information

Flags

md-text

Source string location

docs/Axis_Twist_Compensation.md:block • 2 • (paragraph)

String age

6 months ago

Last updated

6 months ago

Source string age

6 months ago

Translation file

docs/locales/pl/LC_MESSAGES/Axis_Twist_Compensation.po, string 2